SEW-Eurodrive MOVIPRO PHC21A-A075M1-E45C-C5 - Electromagnetic compatibility (EMC)

6
Electrical installation
Electromagnetic compatibility (EMC)
Operating Instructions – MOVIPRO
®
PHC2.A-A..M1-E45C-C5
59
6.5 Electromagnetic compatibility (EMC)
For further information on EMC compliant installation, refer to the following documen-
tation: "Drive Engineering – Practical Implementation, Electromagnetic Compatibility
(EMC) in Drive Engineering".
6.5.1 EMC category
INFORMATION
The product can cause EMC interference within the permitted limit range according to
EN61800‑3.
The product is a drive system of category C3 (see EN61800‑3).
6.5.2 EMC-compliant installation
Ensure that there is a HF-capable equipotential bonding for all drive components. Use
low-impedance, HF-capable connectors such as HF litz wire or ground straps. Stan-
dard PE does not achieve sufficient equipotential bonding regarding HF and EMC. For
more information, refer to chapter "Installing ground connection or equipotential bond-
ing"(→261).
[1]
[4]
[3]
[3]
[3]
[3]
[3]
[3]
[3]
[2]
[3]
[3]
[3]
[3]
[1]
[5]
9007232480091915
[1] HF litz wire, ground strap [4] Machine base
[2] Product [5] Cable duct
[3] PE conductor
26596598/EN – 10/2020