If any malfunction occurs during the extending of the landing
gear:
– Switch Off the LAND GEAR switch/circuit breaker
– Climb to safe altitude where you can continue flight
without stress
– Reduce speed to 120 km/h (65 KIAS)
– Switch On LAND GEAR switch/circuit breaker and extend
the landing gear
– If landing gear is not down and locked, retract landing gear
and then extend it again. Combination of positive and
negative G loads can help to release the system if there is a
mechanical failure
– If one of the landing gear legs is not fully extended and
locked, use the following Emergency Landing Gear Release
procedure;
LAND GEAR switch/circuit breaker Off
Speed Reduce 120 km/h IAS (65 KIAS)
FLAPS FLAPS I
Emergency Release Handle Pull the corresponding red gear-
emergency-handle
Gear position indicators Cross check
To Next Page
Loading...