Shark 600 - Electrical Failures

FLIGHT MANUAL
SHARK 600
Section 3
Emergency
Procedures
2024-02-25
Rev. B
Doc. No.: SHARK600_MA_075
3-15
3.22 Electrical failures
In case of Electrical System failure, there are 3 indicators
providing information about the system status.
1. Charging Indicator: Red LED on left top edge of instrument panel.
Providing primary information about electric regulator status.
Condition
ENG START switch On and
engine not running
LED is flashing due to the generator not
providing energy
Engine is running
LED is Off
Generator provides energy,
regulator provides volts and amps
Engine is running
LED is flashing
In flight: Switch off all
instruments not required for
flight.
Make a precautionary
landing at the closest airport
for maintenance.
LED is flashing
Regulator does not provide energy.
Electrical equipment will use main and
back up batteries. After about 30
minutes the battery is depleted.
LANDING GEAR must be extended by the
Emergency Landing Gear Release
procedure.
Flaps are inoperative and a FLAPS 0
landing must be made.
Radio and Transponder are inoperative.
The engine will operate normally, Dynon
operates normally using its backup
battery, Oblo operates normally using its
backup battery.