Governor and Bowden
Propeller control system electric
Wiring and contact plate and box
Throttle and choke Bowden cables
Secured, free movement to limits
Sensors CHT, MAP, TMOT, TFUEL inspected
Battery, Starter Battery box, fuse, wiring, external plug,
wiring to starter inspected
Heating valve Valve, servo, wiring, exhaust hose
inspected
Brake fluid level Collector bottle level checked - if
installed here. Fill if needed.
Bottom engine cowling Sealing to radiators, landing light, NACA
flap, servo, plexiglass inspected. Winter
plug - adjusted
Oil level check Remove oil tank lid
Turn propeller until “burps”
Check oil amount, refill if needed
Re-fit oil tank lid
Oil access panel door OPEN if OAT is over 30°C and if there is a
risk of vapor lock during taxi
Movable ballast Check position and locate to proper
position according to intended flight
configuration, locking pin secured
To Next Page
Loading...
