Sharp AL-1215

AL-1551CS SIMULATION, TROUBLE CODES 10 - 6
26 06 Destination setup
When this simulation is executed, the current setup of the destination code number is displayed. Enter the code number corresponding
to the destination and press the PRINT switch to enable the setup.
07 Machine conditions check
When this simulation is executed, the current machine setup is displayed.
20 Rear edge void setup
When this simulation is executed, the current setup of the rear edge void code number is displayed. Enter the code number
corresponding to the rear edge void and press the PRINT switch to enable the setup.
30 CE mark support control ON/OFF
When this simulation is executed, the current setup of the CE mark support code number is displayed. Enter the code number
corresponding to the CE mark support setup and press the PRINT switch to enable the setup.
38 Cancel of stop at drum life over
When this simulation is executed, the current setup of the code number is displayed. Enter the code number and press the PRINT
switch to enable the setup.
39 Memory capacity check
When this simulation is executed, the current memory capacity is displayed.
40 Polygon motor OFF time setup (Time required for turning OFF after completion of printing)
When this simulation is executed, the current setup of the code number is displayed. Enter the code number and press the PRINT
switch to enable the setup.
Main
code
Sub
code
Content
Code number Destination
0 Inch series
1 EX JAPAN AB series
2 JAPAN AB series
3 China (EX JAPAN AB series + Chinese paper support)
CPM Copy quantity display
10 cpm 10
12 cpm 12
13 cpm 13
14 cpm 14
15 cpm 15
Code number Rear edge void setup
0 Rear edge void provided * Default
1 Rear edge void not provided
The default for CE-support 200V series is “1.”
Code number CE mark support setup
0 CE mark support control OFF * Default (100V series)
1 CE mark support control ON
Code number Setup
0 Stop at drum life over * Default (AL model)
1 Cancel of stop at drum life over
Code number Setup
88 Mbyte
16 16 Mbyte
Code number Setup
0 0 sec
1 30 sec * Default
2 60 sec
3 90 sec