FINISHER (AR-FN5)
107
6
OPTIONAL EQUIPMENT
3
Use the and keys to select "STAPLE SORT" and press the OK key.
●
Also the OUTPUT key can be used to select an output mode.
4
Set the number of copies and press the START ( ) key.
5
Replace the scanned original with the next original and press the
START ( ) key after it lights up. Repeat this step until all originals
have been scanned.
6
After all originals have been scanned, press the READ-END key.
●
Copying will start and each set of completed copies will be automatically stapled and
delivered to the offset tray.
●
If the message "Can not continue. Remove paper from the offset tray." appears in the
display, remove the copies from the offset tray.
00EX.book107ページ２００１年５月２５日 金曜日 午前１０時４９分
To Next Page
Loading...
