KEY OPERATOR PROGRAMS
132
KEY OPERATOR’S GUIDE
Preheat Mode
Preheat mode functions to reduce the power consumption by lowering the temperature of the fusing
unit to a programmed level once a programmed length of time has elapsed without any copier operation
after the last copy of a run is made or power is turned on. The preheat mode will help lower the user's
electricity bill, reduce waste of natural resources, and cut down on environmental pollution. The
programmed time is set to the factory default of 15 minutes as shipped from the factory. The default
time can be changed optionally within the prescribed range of time. We suggest you set the most
appropriate time according to your usage pattern.
The interval can be set to 1, 2, 5, 10, 15, 30, 60, 120 or 240 minutes.
When "PREHEAT MODE" is selected and the OK key is pressed, the following display will appear.
1. Select the desired time interval using the and keys.
2. Press the OK key.
Message Time
This program is used to adjust the length of time that messages are displayed. The message time can
be set to 3, 6 or 9 seconds. The factory setting is 6 seconds.
When "MESSAGE TIME" is selected and the OK key is pressed, the following display will appear.
1. Select the time using the and keys.
2. Press the OK key.
PREHEAT MODE
15 min.
(1~240)
MESSAGE TIME
SHORT (3sec.)
NORMAL(6sec.)
LONG (9sec.)
00EX.book132ページ２００１年５月２５日 金曜日 午前１０時４９分
To Next Page
Loading...
Need help?
General
