KEY OPERATOR PROGRAMS
133
7
KEY OPERATOR’S GUIDE
Time Out Setting
If a copy job is started while a print or fax job is being run, the print or fax job will be interrupted. This
program is used to adjust the time that elapses before the print or fax job resumes after the copy job is
completed. If a print or fax job is sent to this machine while a copy job is being run, printing of the print
or fax job will start when the programmed time elapses after the copy job is completed. The time can be
set to 0, 10, 30 or 60 seconds. If 0 is set, the print or fax job will resume immediately after a copy run
has finished. (A printer expansion kit or a facsimile expansion kit must be installed to run a print or fax
job.)
When "TIME OUT SETTING" is selected and the OK key is pressed, the following display will appear.
1. Select the desired time using the and keys.
2. Press the OK key.
TIME OUT SETTING
30 sec.
(0~60)
00EX.book133ページ２００１年５月２５日 金曜日 午前１０時４９分
To Next Page
Loading...
Need help?
General
