: Feb. 6 2004
1
AR-M550/M620/M700 DETAILS OF EACH SECTION 6 - 48
3) Remove the fusing cooling fan motor 1 (A), 3 (B), and 4 (C).
a-6. Paper exit temperature sensor
1) Remove the upper cover. (See “a-3. Fusing cooling fan motor 1” in
this section)
2) Remove the paper exit temperature sensor.
a-7. Paper exit detector 1
1) Remove the paper exit unit. (See “a. Paper exit unit” in this section)
2) Remove the follower roller unit.
3) Remove the paper exit detection 1 detector.
a-8. Paper exit detector 2
a-9. Paper exit detector 3
1) Remove the paper exit unit. (See “a. Paper exit unit” in this section)
2) Remove the upper cover. (See “a-3. Fusing cooling fan motor 1” in
this section)
3) Remove the paper exit detection 2 detector (B) and the paper exit
detection 3 detector (A).
a-10. Discharge brush
1) Remove the paper exit unit. (See “a. Paper exit unit” in this section)
2) Remove the discharge brush.
NOTE: When assembling, be careful of the direction of the fan.
1
A
B
C
Fan blowing direction
REVERSE
∗ When attaching the discharge brush, fit the edge with the mark line.
A
B
1
To Next Page
Loading...
