Sharp AR-M550N - Simulation; Adjustment Value;Simulation and Storage Data; Each Storage Data; Simulation Adjustment Value; Set Value Data

: Feb. 9 2004
1
AR-M550/M620/M700 SIMULATION 8 - 1
[8] SIMULATION
1. Adjustment value/Simulation and storage data
A. Simulation adjustment value/ Set value data
1
Each controller is provided with an EEPROM. The adjustment/set values are collected to the MFP controller. If they are changed, they are sent back
and saved.
B. Each storage data
(Data saved by the PCU PWB)
1
MFP CONTROLLER
ENGINE
CONTROLLER
SCANNER
CONTROLLER
LCD
Saved adjustment value send
(When the power is turned on, etc.)
When the value is changed,
it is sent and saved.
1
Counters Adjustment value Other
Drum rotation time counter
(Accumulated time)
Developing bias voltage value Serial number
Developer unit rotation time counter Cleaning mode developing bias voltage value Trouble history
Toner supply time (Block IC CHIP) Main high voltage adjustment Tray 1 size
Drum rotating time (Block IC CHIP) Transfer charger voltage value Tray 2 size
Total counter Transfer belt cleaning voltage value Manual destination information
Maintenance counter Toner concentration reference value
Developing counter Density correction start set time (Developer unit) Tray 3 destination information
Drum counter Density correction rotation time (Developer tank) Tray 4 destination information
Toner cartridge counter Density correction amount (Developer tank) Tray 1 paper remaining quantity data
Valid paper counter Correction execution direction, upper/lower limit
(Developer tank)
Tray 2 paper remaining quantity data
Tray 1 paper feed counter Toner concentration temperature correction (low
temperature side) correction amount
Tray 3 paper remaining quantity data
Tray 2 paper feed counter Toner concentration temperature correction (low
temperature side) set temperature
Tray 4 paper remaining quantity data
Tray 3 paper feed counter Toner concentration temperature correction (low
temperature side) release temperature
Final toner concentration sensor output value
Tray 4 paper feed counter Toner concentration temperature correction (high
temperature) correction amount
Toner cartridge IC CHIP destination
Manual paper feed counter Toner concentration temperature correction (high
temperature side) judgment temperature
Counter mode setting
ADU paper feed counter Toner concentration temperature correction (high
temperature side) judgment voltage
White paper exit count setting
Staple counter Toner concentration temperature correction (high
temperature side) correction value
Trouble memory mode setting
Punch counter Toner concentration temperature correction (low
temperature side) release time
Fusing operation mode (Prevention against curl)
Main unit right-side paper exit
counter
Toner concentration temperature correction (high
temperature side) toner concentration delay time
CE mark conforming operation mode
Side LCC paper feed counter Multi-purpose width adjustment value Maintenance cycle
Inserter counter Manual width adjustment value Print stop setting when developer life over
Saddle staple counter Heater lamp temperature (Center, normal control) Saddle alignment operation priority mode
Lead edge adjustment