Sharp AR-M550N - Simulation List

: Feb. 9 2004
1
AR-M550/M620/M700 SIMULATION 8 - 8
B. Simulation list
(1) Main/ Sub
Code
Function (Purpose) Purpose Section Item
Main Sub
1 1 Used to check the operations of the
scanner (read) unit and its control
circuit.
Operation test/Check Optical (Image
scanning)
Operation
2 Used to check the operation of
sensor and detector in the scanning
(read) section and the related circuit.
Operation test/Check Optical (Image
scanning)
Operation
2 1 Used to check the operations of the
automatic document feeder unit and
the control circuit.
Operation test/Check DSPF Operation
2 Used to check the operations of the
sensors and detectors in the
automatic document feeder unit and
the related circuits.
Operation test/Check DSPF Operation
3 Used to check the operations of the
loads in the automatic document
feeder unit and the control circuits.
Operation test/Check DSPF Operation
3 2 Used to check the operation of
sensor and detector in the finisher
and the related circuit.
Operation test/Check Finisher Operation
3 Used to check the operation of the
load in the finisher and the control
circuit.
Operation test/Check Finisher Operation
10 Finisher (AR-F16) adjustment Adjustment Finisher Operation
30 Used to check the operations of the
sensors and detectors in the
inserter.
Operation test/Check Inserter
31 Used to check the operations of the
loads in the inserter and the related
circuits.
Operation test/Check Inserter Operation
32 Inserter paper width detection level
setting.
Setting (Adjustment) Inserter Operation
4 2 Used to check the operations of the
sensors and detectors in the paper
feed section (large capacity tray) and
the related circuit.
Operation test/Check Paper feed Operation
3 Used to check the operations of the
loads in the paper feed section (large
capacity tray) and the related circuit.
Operation test/Check Paper feed Operation
5 1 Used to check the operation of the
display, LCD in the operation panel,
and control circuit.
Operation test/Check Operation
(Display/Operation
key)
Operation
2 Used to check the operation of the
heater lamp and the control circuit.
Operation test/Check Fixing (Fusing) Operation
3 Used to check the operation of the
scanner lamp and the control circuit.
Operation test/Check Optical (Image
scanning)
Operation
4 Used to check the operation of the
discharge lamp and the related
circuit.
Operation test/Check Process Operation
6 1 Used to check the operation of the
paper transport system loads and
the control circuit.
Operation test/Check Paper transport
(Discharge/
Switchback/
Transport)
Operation
2 Used to check the operations of
each fan motor and its control circuit.
Operation test/Check Other Operation
3 Used to check the operations of the
transfer unit and the related circuit.
Operation test/Check Process (Transfer) Operation