Sharp AR-M550N - Page 267

: Feb. 9 2004
1
AR-M550/M620/M700 SIMULATION 8 - 9
7 1 Used to set the operating conditions
of aging.
Setting Operation
6 Used to set the intermittent aging
cycle.
Setting Operation
8 Used to set the warm-up time display
YES/NO.
Setting Operation
8 1 Used to check and adjust the
operations of the developing voltage
of each color and the control circuit.
Adjustment/Operation
test/Check
Image process
(Photoconductor/
Developing/
Transfer/Cleaning)
2 Used to check and adjust the
operation of the main charger grid
voltage in each printer mode and the
control circuit.
Adjustment/Operation
test/Check
Image process
(Photoconductor/
Developing/
Transfer/Cleaning)
6
Used to check and adjust the
operation of the transfer voltage and
the control circuit.
Adjustment/Operation
test/Check
Image process
(Photoconductor/
Developing/
Transfer/
Cleaning)/Transfer
17
Used to check and adjust the
operation of the transfer voltage and
the related circuit. (Transfer belt
cleaning mode)
Operation test/Check Image process
(Photoconductor/
Developing/
Transfer/Cleaning)
18
Used to check and adjust the voltage
of the transfer CL roller cleaning/
transfer CL roller print mode and the
control circuit. (Not used)
Adjustment/Operation
test/Check
Image process
(Photoconductor/
Developing/
Transfer/Cleaning)
19
Used to check and adjust the fusing
bias voltage and the control circuit.
(Not used)
Adjustment/Operation
test/Check
Fusing
9 1 Used to check and adjust the
operation of the load (clutch/
solenoid) in the duplex section and
the control circuit.
Operation test/Check Duplex Operation
2 Used to check the operations of the
sensors and detectors in the duplex
section and its control circuit.
Operation test/Check Duplex Operation
10 1 Used to check the operations of the
toner motor and the related circuit.
Operation test/Check Process
(Developing)
Operation
2 Used to check the operations of the
toner remaining quantity sensor and
the related circuit.
Operation test/Check Process
(Developing)
Operation
13 0 Used to cancel the self-diag "U1"
trouble. (Only when FAX is
installed.)
Clear/Cancel (Trouble
etc.)
FAX Trouble
14 0
Used to cancel excluding the self-
diag U1/LCC/U2/PF troubles.
Clear/Cancel (Trouble
etc.)
Trouble Error
15 0 Used to cancel the self-diag "U6-09,
F3-12, 22" (large capacity paper
feed tray, paper feed trays 1, 2)
troubles.
Clear/Cancel (Trouble
etc.)
LCC Trouble
16 0 Used to cancel the self-diag U2
troubles.
Clear/Cancel (Trouble
etc.)
MFP control PWB,
PCU PWB,
scanner control
PWB
Trouble
17 0 Used to cancel the PF troubles
(when the copy inhibit command
from the host computer is received).
Clear/Cancel (Trouble
etc.)
Communication
unit (TEL/LIU/
MODEM etc.)
Trouble Error
21 1 Used to set the maintenance cycle. Setting Specifications Counter
Code
Function (Purpose) Purpose Section Item
Main Sub
1
1
1
1
1