Sharp AR-M550N - Lift Wire (Front); Lift Wire (Rear)

AR-M550/M620/M700 DETAILS OF EACH SECTION 6 - 17
4) Remove the torque limiter.
a-5. Lift wire (Rear)
1) Remove the paper feed tray units 1 and 2. (See “a. Paper feed
tray units 1 and 2” in “(Paper feed tray sections 1 and 2)”
2) Remove the E-ring, slide the winding pulley, and loosen the wire.
3) Release the pawl, and remove the wire.
4) Remove the plastic E-ring.
5) Remove the wire.
∗ Pass the nylon clamp.
∗ Attach so that the red wire is on the outside.
∗ Turn it clockwise to fit with the T-shape pin position and insert.
a-6. Lift wire (Front)
1) Remove the paper feed tray 1/2 unit. (See “(Paper feed tray sec-
tions 1 and 2)” in “a. Paper feed tray units 1 and 2”)
2) Push down the tray and remove the screw, and remove the paper
feed tray 1/2 front cabinet.