Sharp AR-M550N - Page 296

: Feb. 9 2004
1
AR-M550/M620/M700 SIMULATION 8 - 38
Operation/Procedure
1) Select the counter to be cleared with 10-key.
2) Press [START] key.
The confirmation to clear is opened.
3) Select Yes/NO of counter clear with 10-key.
YES: Clear
NO: Not clear
4) Press [START] key.
* = SPF, SCAN, STAPLER, PUNCH, STAMP, SADDLE
STAPLER, INSERTER
Operation/Procedure
1) Select the counter to be cleared with 10-key.
2) Press [START] key.
The confirmation to clear is opened.
3) Select Yes/NO of counter clear with 10-key.
YES: Clear
NO: Not clear
4) Press [START] key.
* = MAINTENANCE
Operation/Procedure
1) Select the counter to be cleared with 10-key.
2) Press [START] key.
The confirmation to clear is opened.
3) Select Yes/NO of counter clear with 10-key.
YES: Clear
NO: Not clear
4) Press [START] key.
Operation/Procedure
1) Select the counter to be cleared with 10-key.
2) Press [START] key.
The confirmation to clear is opened.
3) Select Yes/NO of counter clear with 10-key.
YES: Clear
NO: Not clear
24-3
Purpose Data clear
Function
(Purpose)
Used to clear the number of use of the finisher, SPF,
and the scan (reading) unit.
Section
Item Counter
1 SPF SPF paper pass quantity
2 SCAN Number of times of document scan
3 STAPLER Number of times of stapling
4 PUNCH Number of times of punching
5 STAMP Number of times of SPF finish stamp
6 SADDLE STAPLER Number of times of saddle stapling
7 INSERTER Number of times inserter operations
Press [START] key. Press [CUSTOM SETTINGS] key or [START]
key.
24-4
Purpose Data clear
Function
(Purpose)
Used to reset the maintenance counter.
Section
Item Counter
1 MAINTENANCE Maintenance counter
SIMULATION 24-3
ORG./STAPLE COUNTER DATA CLEAR. SELECT1-8, AND PRESS
START.
1. SPF
2. SCAN
3. STAPLER
4. PUNCH
5. STAMP
6. SADDLE STAPLER
7. INSERTER
8. INSERTER OFF LINE
1
SIMULATION 24-3
* COUNTER DATA CLEAR.
ARE YOU SURE?
1. YES
2. NO
1
Press [START] key. Press [CUSTOM SETTINGS] key or [START] key.
24-5
Purpose Data clear
Function
(Purpose)
Used to reset the developer counter. (The developer
counter of the DV unit which is installed is reset.)
Section Image process (Photoconductor/Developing/Transfer/
Cleaning)
Item Counter Developer
1 DV CARTRIDGE Developer cartridge
Press [START] key. Press [CUSTOM SETTINGS] key or [START] key.
* = DV CARTRIDGE
24-6
Purpose Data clear
Function
(Purpose)
Used to reset the copy counter.
Section
Item Counter Copy
SIMULATION 24-4
MAINTENANCE COUNTER DATA CLEAR. PRESS START.
1. MAINTENANCE
1
SIMULATION 24-4
* COUNTER DATA CLEAR.
ARE YOU SURE?
1. YES
2. NO
1
SIMULATION 24-5
DEVELOPER COUNTER DATA CLEAR. PRESS START.
1. DV CARTRIDGE
1
SIMULATION 24-5
* COUNTER DATA CLEAR.
ARE YOU SURE?
1. YES
2. NO
1
1