AR-M550/M620/M700 SIMULATION 8 - 95
Operation/Procedure
1) Select YES/NO of data clear.
2) Press [START] key.
Operation/Procedure
The TEL/LIU state is displayed.
When the state is changed, it is highlighted.
Operation/Procedure
1) Enter the number corresponding to the check item with 10-key.
2) Press [START] key.
Operation/Procedure
When check is completed normally, "OK" is displayed. In case of an
error, "NG" is displayed.
(Display message)
Operation/Procedure
The detected signal is highlighted.
Operation/Procedure
Communication test is performed to measure the time (ms).
Send is made under the following conditions.
66-29
Purpose Clear
Function
(Purpose)
Used to clear data related to an address book (one-
touch registration, program registration/expansion,
relay memory box registration, each table content).
Section FAX, Network scanner
Item Data
1 YES Address book data is cleared.
2 NO Not cleared.
66-30
Purpose Operation test/Check
Function
(Purpose)
Used to check the change in the TEL/LIU status.
Section FAX
Item Operation
HS1 Polarity reverse signal
HS2 Polarity reverse signal
RHS Handset hook SW
EXHS External telephone hook SW
66-31
Purpose Operation test/Check
Function
(Purpose)
Used to check the relay operation.
Section FAX
Item Operation
SIMULATION 66-29
ADDRESS DATA CLEAR.
ARE YOU SURE?
1. YES
2. NO
1
1
SIMULATION 66-30
TEL/LIU SENSOR CHECK.
HS1 HS2 RHS EXHS
10001100
12345678
SIMULATION 66-31
TEL/LIU SETTING.
INPUT 0-1, AND PRESS START.
1. MPXA 2. CION 3. MR 4. EC
5. S. 6. CML 7. DP 8.
66-32
Purpose Operation test/Check
Function
(Purpose)
Used to check the receive data (fixed data) from the
line.
Section FAX
Item Operation
CHECKING Checking
OK Checking completed (OK)
NG Checking completed (NG)
66-33
Purpose Operation test/Check
Function
(Purpose)
Used to check the signal (BUSY TONE/CNG/CED/
FNET/DTMF) detection.
Section FAX
Item Operation
66-34
Purpose Operation test/Check
Function
(Purpose)
Used to measure the communication time of test
image data.
Section FAX
Item Operation
Communication means Memory send
Image quality Normal text
Density Light
ECM ON
Sender record OFF
SIMULATION 66-32
RECEIVED DATA CHECK.
CHECKING···.(OK or NG)
SIMULATION 66-33
SIGNAL DETECT CHECK.
BUSY TONE CNG CED FNET DTMF
SIMULATION 66-34
COMMUNICATION TIME DISPLAY.
* * * * * ms
To Next Page
Loading...
