AR-M550/M620/M700 DETAILS OF EACH SECTION 6 - 38
a-4. Resist roller (Drive)
1) Remove the resist roller unit. (See “a. Resist roller unit” in this sec-
tion)
2) Remove the follower roller and the tension spring.
3) Remove the cover on the front side.
4) Remove the transport roller 15.
5) Remove the paper guide.
6) Remove the E-ring, the gear, and the bearing.
7) Remove the coupling on the rear side.
8) Remove the resist roller (Drive).
a-5. Resist roller front paper pass detector
1) Remove the resist roller unit. (See “a. Resist roller unit” in this sec-
tion)
2) Remove the cover. (See “a-1. Resist roller (Idle)” in this section)
3) Remove the sensor.
b. Paper dust cleaner
1) Open the front cabinet. Open the process DV cover.
2) Remove the paper dust cleaner.
To Next Page
Loading...
