7-104
SYSTEM SETTINGS
Contents
Settings for fax transmission can be configured.
Rotation Sending Setting
When transmitting an image that is one of the following
sizes, this function rotates the image counterclockwise
90 degrees. (The setting can be configured separately
for each size.)
5-1/2" x 8-1/2", B5, A5
Quick On Line Sending
When this setting is enabled, the machine starts
transmitting a fax as soon as the first page is scanned.
Transmission takes place at the same time as the
remaining pages are being scanned.
If you disable this setting, transmission will not begin
until all pages have been scanned. Note that this setting
does not apply to manual transmission.
Printing Page Number at Receiver
This setting is used to add the page number to the top of
each fax page printed by the receiving machine.
Date/Own Number Print Position
Setting
This setting determines the position of the date and sender
information printed at the top of faxes by the receiving
machine. To have the information printed outside the
transmitted document image, touch the [Outside the
Original Image] key. To have the information printed inside
the document image, touch [Inside the Original Image] key.
For more information on the print position, see "ADDING
YOUR SENDER INFORMATION TO FAXES (Own
number sending)" (page 4-82) in "4. FACSIMILE".
Recall in Case of Line Busy
This program is used to set the number of recall
attempts and the interval between recall attempts when
a transmission is not successful due to the line being
busy or other reason.
Number of Times to Recall When Line is Busy
This setting specifies whether or not recalling is
performed when the line is busy. When recalling is
performed, you can set the number of recall attempts.
Any number from 1 to 14 can be selected.
Interval to Wait Between Recall Attempts (min.)
When Line is Busy
The interval between recall attempts can be set. Any
number of minutes from 1 to 15 can be selected.
Recall in Case of Communication Error
Settings can be configured for automatic resending of
faxes when transmission fails due to a communication
error.
Number of Times to Recall in Case of Error
This setting determines whether to re-attempt once or
not when a communication error occurs.
Interval to Wait Between Recall Attempts (min.) in
Case of Error
The interval between recall attempts can be set. Any
number of minutes from 1 to 15 can be selected.
Initial Transmission Speed Setting
The transmission speed can be set for all originals.
If you find that communication errors frequently occur
with the currently set transmission speed, gradually
decrease the speed in the following order setting until
errors do not occur.
33.6kbps, 14.4kbps, 9.6kbps, 4.8kbps
Fax Send Settings
Even when this setting is enabled, note that your
machine will not re-attempt a call when manual
transmission or direct transmission is used.
Even when this setting is enabled, note that your
machine will not re-attempt a call when manual
transmission or direct transmission is used.
To Next Page
Loading...
