Sharp LC-26SH330E

TV menu
Features
Select menu language
Selectthemenudisplaylanguage.
1� Press MENU on your remote control and select
Features ≥ Menu language.
2� Press ≤≥ to select your language.
3� Follow the on-screen instructions to exit.
4:3 Mode
SelectaspectratiobehaviorforAutomode.When4:3
isselected,thepicturesizewillfollowWSSorScart
Pin8Spec.If16:9isselected,thepictureformatwill
changetowidescreen.
1� Press MENU on your remote control and select
Features ≥ 4:3 Mode.
2� Press ≤≥ to select the mode your preferred.
3� Follow the on-screen instructions to exit.
Change picture format
Changethepictureformattosuityourcontent.
1� Press ∏ repeatedly to select one of the
following picture formats. Alternatively, press
MENU and select Features > Picture Format.
Auto
The Automatic format
for DTV transports
streams with AFD
information, while
for ATV and SCART
should be with WSS
information.
Normal (Not for HD)
Displays the classic 4:3
format.
NOTE
• ConstantuseoftheNormalpictureformatcancause
screendistortion.
E Assign a channel decoder (For ATV)
Decodersthatdecodechannelscanbeconnected
toSCART.YouhavetoassigntheTVchannelasa
channeltobedecoded.Beforeselectingchannels,
makesureyourTVisconnectedtoSCART.
1� Press MENU on the remote control and select
TV ≥ Channels�
NOTE
• Youarepromptedtoentercurrentpasswordtoenter
ChannelsifChannel Block/Parental Guidance/
Input BlockintheParentalmenuisnotthedefault
setting.
2� Press <> to select Decoder and press OK or
≥ to enter available analogue channel list.
3� Press <> to select the channel to decode.
4� Press OK to mark or cancel.
5� Follow the on-screen instructions to exit.
E Analogue Ch Fine Tune
Youcanmanuallyfinetuneanaloguechannelswhen
receptionispoor.
1� Press MENU on the remote control and select
TV ≥ Channels.
NOTE
• Youarepromptedtoentercurrentpasswordtoenter
ChannelsifChannel Block/Parental Guidance/
Input BlockintheParentalmenuisnotthedefault
setting.
2� Press <> to select Analogue Ch Fine Tune
and press OK or ≥ to enter the analogue
channel list.
3� Press <> to select one channel and press OK
to enter.
4� Press ≤≥ to adjust the frequency.
5� When complete, press OK to set the frequency.
The fine tuned channel is stored under the
current channel number.
6� Follow the on-screen instructions to exit.
E Clean Channel List
Selecttocleanallthechannelsthatstoredinthe
channellist.
1� Press MENU on the remote control and select
TV ≥ Channels�
NOTE
• Youarepromptedtoentercurrentpasswordtoenter
ChannelsifChannel Block/Parental Guidance/
Input BlockintheParentalmenuisnotthedefault
setting.
2� Press <> to select Clean Channel List and
press OK or ≥ to enter.
3� Select OK and press OK on the remote control
to clean channel list.
16