Sharp LC-26SH330E - Page 9

Quick guide
6� Start searching channels
Initial Setup
Channel Scan
First, please connect
antenna.
NextSelectBack
Skip Scan
0 %
Scan
ExitEXIT
Start channel scan now?
If you skip this setup, the
channel scan could be
performed in Menu.
Initial Setup
Channel Scan
The channel scan may take
a while to complete.
10 %
CancelEXIT
Status: Scanning.
Analogue Channels: 0
WhenselectingAnalogue and Digital,thefollowing
screenwillappear.
Initial Setup
Channel Scan
The channel scan may take
a while to complete.
10 %
CancelEXIT
Status: Scanning.
Analogue Channels: 0
Digital Channels: 0
Tuner mode setting
Additional Information about Scan Mode
• Quicksearchmethodoffersthefastestchannelscan.
• Advancedsearchmethodworksonlyincountrieswith
broadcastingaccordingtotheLCNstandard(e.g.UK
andFRANCE).
• Fullsearchmethodtakesalongtime(dependingon
networksituation,about1hour).
Radio channel sorting
• Autosortingwillstoreradiostationsfromprogram
no.1001onwardsincountrieswithoutbroadcasting
accordingtotheLCNstandard.
Watch TV
 Congratulations! Now you can watch TV.
Initial Setup
Completed
Congratulations !!
Completed Initial setup
Please press [OK] to exit
the wizard.
Back
Exit
OK
 If necessary, adjust the antenna to attain
maximum signal reception.
3
3� Mode select (TV location setting)
Initial Setup
Mode select
Please select your mode
SHOP
NextSelectBack
HOME
ExitEXIT
WhenselectingHOMEmode,gotostep 4toselect
thescanmode.
WhenselectingSHOPmode,awindowpopsoutto
askyourconfirmation.
4� Scan Mode setting
Initial Setup
Scan Mode
Please select your scan
mode
Analogue and Digital
NextSelectBack
Analogue
ExitEXIT
WhenselectingAnalogue,gotostep 6tostart
channelscan.
Initial Setup
Scan Mode
Please select your scan
mode
Analogue and Digital
NextSelectBack
Analogue
ExitEXIT
WhenselectingAnalogue and Digital,theTuner
Modescreenwillappear.SelecttheTunermode.
5� Tuner Mode setting
Initial Setup
Tuner Mode
Please select your tuner
mode
Cable
NextSelectBack
Antenna
ExitEXIT
WhenselectingAntenna,gotostep 6tostart
channelscan.
Initial Setup
Tuner Mode
Please select your tuner
mode
Cable
NextSelectBack
Antenna
ExitEXIT
WhenselectingCable,theScanModeconfiguration
screenwillappear.
Please configre the cable
info.
Initial Setup
Scan Mode
Frequency (KHz)
Modulation
Symbol Rate (Ksym/s)
Network ID
Full
64QAM
474000
ExitEXIT
Select
/
NextOK
6875
999
Back
MENU
8