4-23
FACSIMILEâ–ºBASIC TRANSMISSION METHODS
Canceling a stored transmission job
If you do not wish to cancel a stored transmission job and only wish to check its status, press the [BACK] key instead of
the [C] key in step 4 to exit.
1
Press the [FAX STATUS] key.
The fax job status screen is displayed.
When a transmission is in progress, the job being transmitted is displayed. Press the [BACK] key to display the fax
status selection screen.
2
Select "TX/RX Reserve" with the [ ] or [ ] key.
3
Press the [OK] key.
The first stored transmission job appears.
Press the [ ] or [ ] key until the transmission job that you wish to cancel appears.
4
Press the [C] key.
The transmission cancel confirmation screen appears.
5
Select "Yes" with the [ ] or [ ] key.
6
Press the [OK] key.
The selected transmission job is canceled.
If you wish to cancel another transmission job, repeat steps 1 through 6.
To Next Page
Loading...
Need help?
General
