7-16
SYSTEM SETTINGS►SYSTEM SETTINGS
Auto Calibration
If the print tones are off, you can correct the tones. By
scanning the printed test pattern, tones can be
automatically corrected.
After the [OK] is selected and a test patch is printed, a
message appears prompting you to begin automatic
calibration. Place the test patch on the document glass
as shown below (so that the light patch at the edge of
the page is to the left).
Lay copy paper (about five sheets) that is the same size
as the test patch on top of the placed test patch, gently
close the automatic document feeder, and select the
[OK].
Security Settings
The following settings are related to security.
Select the [Security Settings] to configure the settings.
IPsec Settings
IPsec can be used for data transmission/reception on a network.
IKEv1 Settings
Configure the IKEv1 settings.
Enable IPsec
Specify whether or not IPsec is used for transmission.
IKEv1 Settings
Configure the IKEv1 settings.
Pre-Shared Key
Enter the Pre-Shared Key to be used for IKEv1.
SA Lifetime (time)
Set the SA lifetime.
IKE Lifetime
Set the IKE lifetime.
Initialize Private Data and Data in
Machine
The system-set values can be restored to the factory default
state after eliminating the data stored in the machine.
• All information displayed in the fax status
• Image data in memory boxes
• Unsent fax data
• Current values set for system settings
• Current values set for network settings
• User information > User registration information
• User information > Paper limits
• User information > Function usage restrictions
• User information > User counts
(Excluding default users)
• Fax / scanner addresses
•Groups
• User index (scanner)
• Programs
• Auto forwarding of received faxes
• Public box data
• Sender information
• Reception rejection numbers
• Forwarding information
• Product key
If the tones are still off after "Auto Calibration" is
performed, repeating Auto Calibration may provide
improvement.
Align the upper left corner of the original with the
mark.
To Next Page
Loading...
