5-25
SCANNERâ–ºSAVING IN USB MEMORY DEVICE
Using the document glass
5
Connect the USB flash memory to the
machine.
If a USB flash memory is inserted into the machine prior to step 4, the following screen will appear.
Instead of performing steps 3 and 4, you can select "Scan to the memory device" with the [ ] or [ ] key in the above
screen and press the [OK] key to select theUSB flash memory as the destination.
6
Press the [START] key.
Scanning begins.
If scanning is completed normally, "Complete." is appears briefly and then the display returns to the base screen.
1
Make sure the machine is in scan mode.
When the SCAN indicator is lit, the machine is in scan mode. If the indicator is not lit, press the [SCAN] key.
If auditing mode has been enabled for the scan function in the system settings, a message will appear prompting you to
enter your account number when you switch to scan mode. Enter your account number (five digits) with the numeric
keys.
â–º User Authentication
(page 7-12)
2
Place the original.
Place the original on the document glass.
â–º DOCUMENT GLASS
(page 1-32)
You cannot place originals in both the document feeder tray and on the document glass and send them in a single
transmission.
To Next Page
Loading...
Need help?
General
