2-81
COPIER
4
Load the tab paper.
• When using the bypass tray, place the paper with the print
side up.
Place the paper so that the sides with the tabs enter the
machine last.
After loading the tab paper, configure the bypass tray
settings as explained in "MAKING COPIES USING THE
BYPASS TRAY" (page 2-39).
• If tab paper is loaded in tray 3, see "LOADING PAPER IN
PAPER TRAY 3" (page 1-32). After loading tab paper in the
tray, see "PAPER TRAYS" (page 2-11) to select the tray.
The width of the tab paper can be as wide as 8-1/2" x 11" paper (8-1/2") plus 5/8" (or A4 width (210 mm) plus 20 mm).
5
Press the [START] key.
Copying will begin.
If you are using the document glass to copy multiple original pages, copying will take place as you scan each original. If you
have selected sort mode, change originals and press the [START] key. Repeat until all pages have been scanned and then
touch the [Read-End] key.
To cancel scanning and copying...
Press the [STOP] key ( ).
To cancel tab copy...
Touch the [Cancel] key in the screen of step 3.
System Settings (Administrator): Initial Tab Copy Setting
The default image shift width can be set from 0" to 5/8" (0 mm to 20 mm). The factory default setting is "1/2" (10 mm)".
To Next Page
Loading...
Need help?
General
