7-16
SYSTEM SETTINGS
Custom Size Registration (Bypass)
If you frequently use a special non-standard paper size in the bypass tray, you can store that paper size.
Storing the paper size saves you the trouble of setting the size each time you need to use it.
Up to three paper sizes can be stored.
Touch the key ([Custom 1] to [Custom 3]) in which you wish to store or change a paper size. The following screen will
appear:
Select whether you wish to enter the size in inches ("Size Input-Inch") or mm ("Size Input-AB"), and then set the X and Y
dimensions of the paper.
"Size Input-Inch"
The X dimension can be set to a value from 5-1/2 " to 17". The factory default setting is 17".
The Y dimension can be set to a value from 5-1/2" to 11-5/8". The factory default setting is 11".
"Size Input-AB"
The X dimension can be set to a value from 148 mm to 432 mm. The factory default setting is 420 mm.
The Y dimension can be set to a value from 100 mm to 297 mm. The factory default setting is 297 mm.
System Settings
Custom 1
OKCancel
17
11
Size Input-AB
Size Input-Inch
Inch
X
Y
Inch
To Next Page
Loading...
Need help?
General
