Copyright © All rights reserved, SHARP CORPORATION
Confidential
29
3.4.Installation flow
Repacking, Repairing
Make sure to check the operation and the display
so that you wouldn’t have to detach displays if
initial failure is confirmed after the completion of
installation.
Install with the protective film and corner
protective materials reattached to protect
displays from flaws in installation.
Check the operation and the display
Reattach the protective film and corner
protective materials
1. Open
the package
2. Remove the protective
film and corner protective
materials
OK
Note: Keep the packing
materials till the
completion of installation.
NG
3. Check the
operation and the
display
4. Reattach the protective film
and corner protective materials
5. Install
7. Combine8. Turn on (completion)
6. Remove the protective
film and corner protective
materials
NG
To Next Page
Loading...
