Copyright © All rights reserved, SHARP CORPORATION
Confidential
35
3.7.Attachment precautions
Rear cover of display
Precautions for using screw holes in the back side of the display.
- Use more than 4 mounting screws to fix the display.
- Use screw holes symmetrically across the centre line.
*It may cause malfunction or deformation of the display to use screw holes asymmetrically.
- Use mounting bracket holes of 7.5mm or below in diameter.
*Too large hole may cause the installed display to fall out.
- Use the appropriate length of screws stipulated in the operation manual.
*Too long screw may cause the installed display to fall out.
- Prevent screws from loosening. (e.g. by using screws with washer)
- Screw torques tight with 3N*m or below. (Tightening torque: 3N*m )
Hole for mounting bracket
(7.5 mm or below in diameter)
Length of screw : 8-10mm
VESA compliant screw holes
Screw (M6)
Fixing boss
Mounting bracket
Rear cover of display
VESA compliant Mounting bracket for the display (M6 screw)
To Next Page
Loading...
