Sharp PN-V701 - Page 45

Copyright © All rights reserved, SHARP CORPORATION
Confidential
44
The setting for the horizontal installation in the OSD menu is required when displays are installed
horizontally.
Face-up horizontal installation setting
3.12. Precautions for horizontal installation (Settings)
・When using remote controller
1. Press the [FUNCTION] button and press the [MENU]
button within 10 seconds.
2. Press the [ ] [ ] [ ] [ ] button.
3. Press the [ ] button, and change from [VERTICAL]
to [FACE UP].
4. Turn off the power after confirming the display.
・When using key on the rear panel
1. Press the [MENU] button and the [INPUT] button at the same time
until [F] is displayed on the top left of the screen display. When [F]
is displayed, press the [MENU] button.
2. Press the [ ] [ ] [ ] [ ] button.
3. Press the [ ] button (left of the [POWER] button viewed from the
front), and change from [VERTICAL] to [FACE UP].
4. Turn off the power after confirming the display.
Notes:
- When you restore to vertical portrait/landscape installation, change to [VERTICAL].
- Do not try any other settings except for the above.
- Do not change to [FACE DOWN] as this model supports only face-up in the horizontal installation.