XXXXXXXXXXXXXXXX
GB-4
ITALIANOESPAÑOL
ENGLISH
ACCESSORIES
Check to make sure the following accessories are supplied:
15 Turntable 16 Turntable support 17 Low Rack
(height: 4 cm) 18 High Rack (height: 15,5 cm)
19 Square Tin (x2).
• Place the turntable support into the coupling in
the centre of the oven floor, ensuring you place
it TOP side up, (TOP is engraved on one side). It
should be able to freely rotate around the coupling.
• Place the turntable on to the turntable support.
• Place the high/low racks onto the turntable if
necessary. These racks are used for cooking in
Convection, Dual or Grill mode.
• Use the square tin for convection only. See page
GB-15. When using one square tin, place it at rail 2
as shown in the diagram A.
NOTES:
• Always operate the oven with the turntable and
support fitted correctly. This promotes thorough even
cooking. A badly fitted turntable may rattle, may not
rotate properly and damage the oven.
• The turntable rotates clockwise or counter clockwise.
The rotary direction may change each time you start
the oven. This does not affect cooking performance.
• When you order accessories, please mention two
details: part name and model name to your dealer
or SHARP authorised service facility.
18 <High Rack>
17 <Low Rack>
15
16
9
GB
<Rack + Turntable>
19
A
ACCESSORIES
19 <Square Tin>
(x2)
To Next Page
Loading...
Need help?
General
