Sharp UX-1300

SENDING DOCUMENTS
Rapid Key Dialing
lf the number you want to dial has been stored for automatic dialing as a Speed
Dial number from "01" to "20" (see "Storing Numbers for Automatic Dialing" in
Chapter 2), you can dial it by pressing the corresponding Rapid Key.
Cs ee ee Press the Rapid Key corresponding to
the desired Speed Dial number.
e The name of the receiving party will ap-
pear in the display. If no name was
stored, the fax number will appear. (If
the name or number is incorrect, press
the STOP key.)
e The document will be automatically
Example: To dial Speed transmitted once the connection is
Dial number "02", press made.
Rapid Key 02.
Speed Dialing
Speed Dialing can be used to dial any number which has been stored for automatic
dialing (see "Storing Numbers for Automatic Dialing" in Chapter 2).
1 Press the SPEED DIAL key and then
enter the two digits of the Speed Dial
SeeeO BIL number by pressing the number keys.
e To enter numbers 1 through 9, first en-
ter 0 and then the number.
Check the display. If the name or num-
ber shown is correct, press the START
key. (If not, press the STOP key and
then repeat Step 1.)
3-8 FAX OPERATIONS