Sharp XV-Z12000 User Manual

Image Projection
Basic Procedure
Connect the required external equipment to
the projector before operating the following
procedures.
Info
• The language preset at the factory is English.
If you want to change the on-screen display
to another language, reset the language ac-
cording to the procedure on page
36 .
1 Plug the power cord into the
wall outlet.
• The power indicator illuminates red, and
the projector enters standby mode.
2 Press on the remote control
or
on the projector.
• The power indicator illuminates blue.
After the lamp indicator illuminates, the
projector is ready to start operation.
Note
• The lamp indicator illuminates, indi-
cating the status of the lamp.
Blue: The lamp is ready.
Blue blinking: The lamp is
warming up.
Red:
The lamp should be replaced.
• If the projector is put into the
standby mode and immediately
turned on again, the lamp indicator
may take some time to illuminate.
• When controlling the projector using
RS-232C commands from a com-
puter, wait for at least 30 seconds
after the power has been turned on,
and then transmit the commands.
-34
INPUT
button
ON button
STANDBY
button
MENU button
", ',\, | buttons
ENTER
button
ON button
INPUT
buttons
", ', \, |
buttons
MENU button
ENTER
button
STANDBY
button
Lamp indicator
Power indicator
XV_Z12000_E_US_p33_41.p65 03.9.24, 1:59 PM34

Sharp XV-Z12000 Specifications

General

Brand	Sharp
Model	XV-Z12000
Category	Projector
Language	English