Basic Operation
-49
IP Mode
This function allows you to select the progres-
sive display of a video signal. The progres-
sive display projects a smoother video image.
Select “IP Mode” in the “Specials”
menu on the “Picture” menu screen.
•“IP Mode” is switched by pressing .
➝For operating the menu screen, see
pages 42 to 45.
*
The film source is a digital video recording with the
original encoded as is at 24 frames/second. The pro-
jector can convert this film source to progressive video
at 60 frames/second with NTSC and PAL60Hz or at
50 frames/second with PAL50Hz and SECAM to play
back a high-definition image.
Note
•
When using progressive inputs, inputs are
directly displayed so that 2D Progressive, 3D
Progressive and Film Mode cannot be se-
lected. These modes can be selected in in-
terlace signals other than 1080
I.
•
In NTSC or PAL60Hz, even if the 3D Progres-
sive mode has been set, the three-two pull
down enhancement will be enabled automati-
cally when the film source has been entered.
•
In PAL50Hz or SECAM, the two-two pull down
enhancement will be enabled only in the Film
Mode, when the film source has been entered.
Description
Useful to display fast-moving
images such as sports and
action films. This mode
optimizes the image in a
displayed frame.
Useful to display relatively
slow-moving images such as
drama and documentary
more clearly.
This mode optimizes the
image by estimating the
movement of a number of
preceding and succeeding
frames.
Reproduces the image of film
source* clearly. Displays the
optimized image of film
transformed with three-two
pull down (NTSC and
PAL60Hz) or two-two pull
down (PAL50Hz and
SECAM) enhancement to
progressive mode images.
Selected Item
(2D Progressive)
(3D Progressive)
(Film Mode)
XV_Z12000_E_US_p42_60.p65 03.9.24, 2:02 PM49
To Next Page
Loading...
