EN.
14
Alarm Mode
Overcurrent detected O
The LED will be blinking red in Mode 4
Overheat detected
The LED will be blinking red in Mode 4
Overvoltage detected
The LED will be blinking red in Mode 4
10. Z-Wave® Parameters
Parameter No. 17 - Restore the O (O1) state after a power failure
This parameter determines if the on/off status is saved and restored for the load connected to
O (O1) after a power failure.
Values size: 1 Byte
Default value: 0
Values & descriptions:
• 0 - Device saves last on/off status and restores it after a power failure
• 1 - Device does not save on/off status and does not restore it after a power failure, it
remains off
To Next Page
Loading...
