EN.
25
13.1 Root device
Root device - Association Group 1 - Lifeline
1. INDICATOR_REPORT: LED status
2. DEVICE_RESET_LOCALLY_NOTIFICATION: triggered upon request.
3. SWITCH_BINARY_REPORT: status change report for output O (O1)
4. NOTIFICATION_REPORT: triggered on Overheat.
5. NOTIFICATION_REPORT: triggered on Overcurrent detected O (O1)
6. NOTIFICATION_REPORT: triggered on Overvoltage detected.
7. METER_REPORT: triggered by load power consumption (according to the settings of
Parameters from No. 36 to 39)
Root device - Association Group 2
Association Group 2
Allowed nodes: 9
It is assigned to output O (O1) (uses Basic command class).
Triggered by O (O1). Supports the following command classes:
• BASIC_SET: set On/Off state at the associated device
14. Supported load types
• Resistive (incandescent bulbs, heating devices)
• Inductive (LED light drivers, transformers, fans, refrigerators, air-conditioners)
• Capacitive (capacitor banks, electronic equipment, motor start capacitors)
To Next Page
Loading...
