18/54
• Install the wrist pin into the piston and
connecting rod using the tool and lightly tapping
with a hammer.
• Install the opposite circlip, using the
special tool.
• Install the cylinder over the piston using
an appropriate ring compressor.
• Install the two cylinder head locating pins
[A].
• Install the head gasket [B].
• Install the cylinder head.
• Install the head bolts noting the different
lengths; tighten them using two passes in the
order shown in the photo.
• Install and tighten the two M6 nuts.
Cylinder head torque:
Studs 1
st
pass: 30 Nm
2
nd
pass: 50 Nm
Nuts M6: 10 Nm
The two internal bolts are of different
length and are equipped with washers.
To Next Page
Loading...
Need help?
General
