27/54
• Remove the flywheel using special tool
number R462.
• Remove the two starter shafts along with
the starter gears.
• Remove the oil centrifuge (anti blowby)
Attention the threads this screw are LH,
do not turn the wrong direction.
• Remove the freewheel. (see photo)
Inspect the freewheel and the needle bearings:
• Visually inspect the caged needle bearings.
• Replace if necessary.
• Inspect the condition of the freewheel.
• Replace if necessary.
• Finally check the rollers on the freewheel.
• Replace if necessary.
If the freewheel must be replaced then
the rest of the gears must be replaced and vice
versa.
To Next Page
Loading...
Need help?
General
