ENGLISH
Memorizing the adjusted channel levels
• The "1" of "REF 1" indication flickers for several
seconds.
• You can memorize the adjusted channel levels into preset memory("REF 1", "REF 2") and recall the memorized
whenever you want.
• "CAL " (or "REF 1", etc.) is displayed for several
seconds.
• If the channel level mode display disappears, press
this button again.
• The adjusted channel levels have now been
memorized into the selected memory.
• If the preset memory disappears, perform the
above step 1 again.
1. After performing the steps 1 ~ 4 in "Adjusting the
current channel level" procedure on page 20,
press the ENTER(/MEMORY) button.
Recalling the memorized channel levels
• Then the channel levels memorized into the
selected preset memory are recalled.
2. Select the desired one of REF 1 and REF 2.
3. Confirm your selection.
1. Press the CHANNEL LEVEL button. 2. Select the desired one of REF 1 and REF 2.
21
RD7405(A)100225_RD7405(A).qxp 2010-03-09 오전 9:47 페이지 21
To Next Page
Loading...
Need help?
General
