ENGLISH
20
ENGLISH
Adjusting the current channel level
• Each time these buttons are pressed, the
corresponding channel is selected as follows:
→ REF 1, 2(or CAL) ↔ FL ↔ C ↔ FR ↔ SR ←
→ <DD> ↔ SW ↔ SL(↔ SB) or (↔ SBL ↔ SBR) ←
( ) : Possible depending on whether the surround back
speaker is set to 2ch(“L2”, “S2”) or 1ch(“L1”, “S1”).
< >: Possible only when the digital signals from Dolby Digital
program sources that include LFE signal are input.
• Depending on the speaker settings ("N(No)") and
surround mode, etc., some channels cannot be
selected.
• When the SPEAKER button is set to off, only the
Front Left, Front Right(and LFE) channels can be
selected.
• After adjusting each channel level with test tone, adjust the channel levels either according to the program
sources or to suit your tastes.
• You can adjust the current channel levels as desired. These adjusted levels are just memorized into user’s
memory ("CAL"), not into preset memory("REF 1", "REF 2").
• The LFE level can be adjusted within the range of -10
~ 0 dB and other channel levels within the range of -15
~ +15 dB.
• In general, we recommend the LFE level to be
adjusted to 0 dB. If the recommended levels seem
too high, lower the setting as necessary.
• Then the memory mode ("CAL", etc.) is displayed
for several seconds.
• When the memory mode or channel level
disappears, press this button again.
1. Press the CHANNEL LEVEL button.
2. Select the desired channel.
3. Adjust the level of the selected channel as
desired.
4. Repeat the above steps 2 and 3 to adjust each
channel level.
RD7405(A)100225_RD7405(A).qxp 2010-03-09 오전 9:47 페이지 20
To Next Page
Loading...
Need help?
General
