ENGLISH
37
■When selecting the desired unit
• You can select either "FT (Feet)" or "M (Meter)" .
• Once a unit is selected, the distances are
automatically changed in the selected unit.
■When setting the distance
• You can set the distance within the range of 0 ~ 30
feet in 1 feet intervals (or 0.0 ~ 9.0 meters in 0.3
meter intervals).
When selecting the DISTANCE
■Note :
• You cannot select the speakers set to "N(No)".
■About the speaker distance
When enjoying multi-channel surround playback with Dolby Digital sources, etc., it is ideal that the center,
surround, surround back and subwoofer speakers should be the same distance from the main listening position as
the front speakers. By entering the distance between the listening position and each speaker, the delay times of
center, surround, surround back and subwoofer speakers are automatically adjusted to create an ideal listening
environment virtually as if the center, surround, surround back and subwoofer speakers were at their ideal
locations respectively.
3. Press the CURSOR LEFT(◀)/RIGHT(▶)
buttons to set the selected item as desired.
1. Press the CURSOR UP(▲)/DOWN(▼) buttons
to select the DISTANCE, then press the ENTER
button.
4. Repeat the above steps 2 and 3 until the
distances are all set as desired.
2. Press the CURSOR UP(▲)/DOWN(▼) buttons
to select the desired item.
RD7405(A)100225_RD7405(A).qxp 2010-03-09 오전 9:47 페이지 37
To Next Page
Loading...
Need help?
General
