Shield Fire, Safety and Security Ltd.
Shield A-XT Releasing Fire Control Panel - Installation and Operation Manual SEXTCP-OM
Revision E01.00
2 of 127
Introduction 1
Using This Manual
The following sections provide instructions for installing, testing and troubleshooting the Shield A-XT Releasing
Fire Control Panel:
Section 1 Introduction provides document conventions, the technical help-line, repair and return
information.
Section 2 Overview provides a summary features of the Shield A-XT Releasing Fire Control Panel.
Section 3 Installation describes how to setup, install, test and troubleshoot the A-XT Releasing Fire
Control Panel.
Section 4 Operation describes how to initiate Access Level 2 or Access Level 3, identify Alarm
Conditions, Controls and Indicators, understand Relay Contacts and how to Configure Ancillary Cir-
cuit Boards.
Section 5 Maintenance and Repair describes how to maintain and repair the A-XT Releasing
Fire Control Panel.
Appendix A Specifications provides characteristics of the Shield A-XT Releasing Fire Control Panel.
Appendix B Equipment List provides model numbers for Shield A-XT Releasing Fire Control Panels, loop
devices, accessories, replacement parts and compatible Notification Appliances.
Appendix C Calculations provides calculations for determining load capacity, battery rating, and wiring length
of the Shield A-XT Releasing Fire Control Panel.
Appendix D Wiring Diagram is a copy of the wiring diagram used for shipping with A-XT Releasing
Fire Control Panel.
Appendix E Operating Instructions provides an overview of Shield A-XT Releasing Fire Control Panel
status and control instructions.
Appendix F UL Compliance Label is a copy of the compliance label applied to the cabinet door of the
Shield A-XT Releasing Fire Control Panel
Appendix G UL Permitted Configurations provides UL authorized codes for programming the Shield A-
XT Releasing Fire Control Panel.
To Next Page
Loading...