Shimadzu AP124X - Page 107

107
1
3
5
2
4
6
7
8
12
14
13
9
10
11
77 ApplicationsApplications
 Element Number Output (Add-on mode)
A function that can set the numbers to each sample automatically to the output results.
1. Call out the Add-on mode setting function
(1) Press [ MENU] with the Add-on mode in the
measurement ready status.
(2) Select [Print], and then press [ OK].
2. Set element number output at ON or OFF
(1) Select [Element No. output], and then press
[ OK].
(2) Select [on] or [off], and then press [ OK].
3. Return to the Add-on mode’s weight measurement mode
Press [ POWER].
Element No.
Calculated value
of each element
(this will be output
regardless of
whether element
number output is
set at ON or OFF.)
 Total Weight Output (Add-on mode)
A function to output the total weight at the same time as the display. The total weight will be output
together with the term [TOTAL =].
1. Call out the Add-on mode setting function
(1) Press [ MENU] when the Add-on mode is in the measurement ready status.
(2) Select [Print], and then press [ OK].