Shimadzu AP124X - Page 23

23
11 SetupSetup
1
3
5
2
4
6
7
8
12
14
13
9
10
11
Use the multi-stand according to the application and refer to the illustrations below for
attachment directions.
(When using medical packaging paper) (When weighing a cylindrical sample) (When using a micro-tube)
Install upside
down
Align the hole at the center of the
multi-stand with the protrusion at the
center of the fixing pan, as shown in
the illustration, and attach.
Align the hole at the center of the
multi-stand with the protrusion at the
center of the fixing pan, as shown in
the illustration, and attach.
Turn the multi-stand upside down
as shown in the illustration above
and align with the outer protrusion
on the fixing pan and attach.
Make folds on the medical packaging
paper and place onto the stand.
Use the notches on the stand, as
shown in the illustration, and place
the long sample onto the stand.
Insert the micro-tube into the hole at
the center of the stand.
6. Use the AP Holder (AP225W-AD/ AP225W only) when necessary.
The AP Holder is used for measuring net weight of volumetric flasks, test tubes, and other
vessels or containers with narrow openings and deep shapes. The AP Holder can be placed
directly on the weighing pan for use. Using the AP Holder together with the ionizer allows for
efficient elimination of static electricity from the bottoms and surfaces of volumetric flasks and
other containers to allow for accurate measurement.
Attach the AP Holder as shown in the illustration below and use as appropriate for applications.
Set the AP Holder in the center of the weighing pan so that it does not contact the surrounding shield case or stage as
shown in the illustration below.
(When placing a test tube) (When placing a 10 mL volumetric flask) (When placing a 100 mL volumetric flask)
Place at an angle as shown in the
illustration above so that the opening
is to the upper-right to make it easier
to pour samples.
Place at an angle as shown in the
illustration above so that the opening
is to the upper-right to make it easier
to pour samples.
Place at an angle as shown in the
illustration above so that the opening
is to the upper-right to make it easier
to pour samples.