Shimadzu GC-2010 - Setting the Temperature of the Column Oven and the Injection Port

3 Basic Operation
3.8
3.
22 FPD-2010
3.8Setting the Temperature of the Column Oven
and the Injection Port
Set the column oven temperature and the sample injection port temperature. For the detailed procedure,
refer to
“11. Setting the Oven Temperature Program” and “12. Injection Port” in the GC-2010 Instruction
Manual.
For the sample injection port, select the Sample Injection Port screen using the [INJ] key and set the
temperature.
Fig. 3.8.1