4 Key Operations
4.1 Key operation of FPD
48 FPD-2010
4.1.7 Zero Adjustment
Zero adjustment procedure
1. Select the detector to perform zero adjustment.
2. Perform key operation.
3. Make zero adjustment of the data processing unit. (For the operation method, refer to the
instruction manual of the data processing unit such as Chromatopac.)
Selecting the detector to perform zero point adjustment.
Zero adjustment is performed on the Monitor screen.
This section describes zero adjustment only. For the details of the monitor screen, refer to "9.
Monitor" in the GC-2010 Instruction Manual.
Pressing the [MONIT] key displays the main screen. When the displayed line configuration does
not include the FPD, press [Chng.Line] of the PF menu and change the line. (If [Chng.Line] is not
displayed in the PF menu, press the toggle key to show it, and then change the line.)
Fig. 4.1.12
To Next Page
Loading...
