1 Installation Procedures
1-2
1.2 Installing Software
The following installation procedures assume that you are installing from a CD-ROM.
Procedure
1) Gather a CD-ROM disk for CLASS-Agent Software. Then insert the CD-ROM disk into
your CD-ROM drive.
2) With the CD-ROM disk inserted, the installation wizard appears as shown below.
[NOTE]
If the installation wizard does not automatically start up, or if you reboot the
Windows program, you can install programs by using the Run command in
MS-Windows 95/98/NT. Choose [Start] ® [Run] to open the <Run> dialog box.
Click the [Browse] button and then choose a SETUP.EXE program from the root
folder on the CD-ROM. Then click on the OK button to run the setup program.
- The <Run> dialog box -
To Next Page
Loading...
