Ramp status, Soak Status Special case matter
Soak status can be released by , power off ,next Ramp start and Event mode change at Event Latching
OFF.
Ｓｏａｋ ｓｔａｔｕｓ
At the status of EV Latching ON, Soak signal can be released by power off or EV latching off. Soak
signal will be turned off when timer cleared. (Latching off status)
Event/DO cannot be activate when SV No, changed before Status time is not up.
Operation example of repeat Ramp operation
ＳＶ Change
Soak signal can be allotted without Ramp function. But this is only like time signal.
Execution ＳＶ－Ｎｏ＝１
Ｒａｍｐ time
To Next Page
Loading...
