49(83)
missing, then the operator won't be able to log into the system parameter
setup screen. It is better to preserve this password either by system
administrator or senior operator.
After input correct password, the screen will show the following "temperature
parameter setting" screen. Shown as below:
Picture 2-21:Temperature Parameters Setting 2
Regeneration Temperature Parameter Setting:
By touching "PID" button, the system will pop up the temperature control PID
screen in which three parameters can be set, such as: Proportion, Integral
Time and Differential Time.
Picture 2-22:Process temp. Parameters Setting 1
If to change any parameters, it’s only need to touch the corresponding "input
area" and then a numeric keypad will pop up. Input a new parameter and press