Mark VII Restored Manual - V1.02 – Donated without cost to the world-wide Shopsmith Community - Everett L. Davis 2016 16
SHOPSMITH 10-INCH SAW
NOMENCLATURE
1. Rip fence lock handle - Depressing handle into fence automatically squares fence to table and locks it front and
rear.
2. Angling screws - To set fence slightly out of parallel, for special set ups or operations, without disturbing basic
parallel setting of fence.
3. Miter gauge plunger - Pin against which auto-stop set screws bear at 45, 90 and 45 degrees.
4. Safety grip - Provides safe, positive grip for square or angle cuts.
5. Miter gauge lock - Locks miter gauge settings.
6. Miter gauge extension slots - For mounting miter gauge extensions.
7. Miter gauge lock screw - Locks miter gauge in table slot for jig setting.
8. Insert - Removable insert is coined and “bowed" for accurate, flush fit; integral projections prevent saw blade
cutting insert.
9. Stop rod holes - Permit mounting of miter gauge stop rods for duplicate cutting.
10. Saw blade - 10" all-purpose blade furnished. Always mounted on main spindle.
11. Saw arbor - 1-1/4" - Blade stays mounted on arbor - Tools can be changed in seconds
12. Table tubes - Rack cut for raising or lowering table.
13. Inter latch release - Pushing button releases latch. Pulling button engages latch.
14. Inter latch rod - Latches carriage to headstock at sawing position for either table slot.
15. Table tilt locks - Lock table at any angular setting, both front and rear- for heavy work.
16. Trunnion plunger - Pin against which auto-stop set screws bear at 0 and 45 degrees.
17. Trunnion - Guides table through tilt range - calibrated for angular settings.
18. Table height control - Turn wheel crank to raise or lower table. Turn wing nut in center to lock or unlock height
setting.
19. Carriage lock - One quarter turn clockwise locks carriage in any position along tubes.
20. Cap screws - Hold table to trunnions front and rear. Loosen for table alignment.
21. Table auto-stop screws for drill press - Adjustable Nylok set screws provide automatic 90 degree setting.
22. Trunnion vernier plate - Adjustable, stamped plate for tilting table to exact degree.
23. Trunnion auto-stop set screws – Adjustable Nylok set screws afford automatic settings at most used angular
settings.
24. Table auto-stop screws - for shaper operations.
To Next Page
Loading...