Mark VII Restored Manual - V1.02 – Donated without cost to the world-wide Shopsmith Community - Everett L. Davis 2016 26
MITER GAUGE EXTENSION
The miter gauge extension lends much additional
support and increases accuracy on such operations as
crosscutting and mitering. It is made of sturdy
hardwood and may be used with the miter gauge
situated in either table slot. Some operators make a
saw cut in the extension after it is mounted and
thereafter use it as a guide for positioning work for
cross-cutting. (Item No. 505630)
SHOPSMITH 16 1/2 INCH DRILL PRESS
NOMENCLATURE
1. Quill feed lever - May be used on either side of
headstock. Positions radially merely by .unscrewing a
few turns.
2. Feed stop - Turning clockwise locks setting for
controlled depth drilling.
3. Depth control dial - Dial to depth setting required.
Setting locked with feed stop.
4. Drill chuck - Three jaw chuck for drills and tools with
shanks from 5/64" to l/2” diameter.
5. Quill lock - Turning clockwise locks quill in any
extended position for routing, shaping, and many
other operations.
6. Safety latch - Holds SHOPSMITH in vertical drill press
position.
To Next Page
Loading...