Shopsmith Mark VII - Table of Contents

Mark VII Restored Manual - V1.02 – Donated without cost to the world-wide Shopsmith Community - Everett L. Davis 2016 3
TABLE OF CONTENTS
WE KNOW YOU ARE ANXIOUS TO USE YOUR NEW SHOPSMITH - BUT .................................................................. 2
SPEED DIAL SETTING ........................................................................................................................................... 2
TABLE OF CONTENTS ............................................................................................................................................... 3
MARK VII NOMENCLATURE ................................................................................................................................. 7
STANDARD ATTACHMENTS ................................................................................................................................. 8
PLUG-IN INSTALLATION ...................................................................................................................................... 8
CHECKING FOR ACCURACY................................................................................................................................ 12
1 - AT "0" TRUNNION SETTING, THE TABLE MUST BE SQUARE TO THE SAW BLADE ................................... 12
IF TABLE, WITH TRUNNION SET AT "0," IS NOT EXACTLY 90 DEGREES TO SAW BLADE ............................... 12
2 TABLE SLOTS MUST BE PARALLEL TO SAW ................................................................................................ 12
IF TABLE SLOTS ARE NOT PARALLEL TO SAW BLADE .................................................................................... 13
3 THE MITER GAUGE, WHEN SET AT 90 DEGREES, MUST BE AT RIGHT ANGLES TO THE TABLE SLOTS. ...... 13
IF MITER GAUGE, AT 90 DEGREE SETTING, IS NOT EXACTLY SQUARE TO BLADE ......................................... 14
4 THE RIP FENCE, WHEN LOCKED, MUST BE PARALLEL TO THE TABLE SLOTS .............................................. 14
IF RIP FENCE IS NOT EXACTLY PARALLEL TO TABLE SLOTS ............................................................................ 14
5 THE EXTENSION TABLE MUST BE ALIGNED WITH SAW TABLE .................................................................. 14
IF IT IS NOT IN LINE ACROSS THE FRONT: ..................................................................................................... 14
IF IT IS NOT PARALLEL TO MAIN TABLE AFTER ABOVE CHECKS .................................................................... 15
SHOPSMITH 10-INCH SAW .................................................................................................................................... 16
NOMENCLATURE ............................................................................................................................................... 16
HOW TO USE THE TABLE SAW .......................................................................................................................... 17
POSITIONING THE POWER HEAD .................................................................................................................. 17
MOUNTING THE SAW BLADE ........................................................................................................................ 17
POSITIONING THE TABLE .............................................................................................................................. 17
BLADE PROJECTION ....................................................................................................................................... 18
BLADE TO FENCE SETTINGS ........................................................................................................................... 18
CROSSCUTTING ............................................................................................................................................. 19
MITER GAUGE SAFETY GRIP .......................................................................................................................... 19
MITER CUTS ................................................................................................................................................... 19
CUTTING OFF DUPLICATE LENGTHS .............................................................................................................. 20
RIPPING ......................................................................................................................................................... 20
BEVEL RIPPING .............................................................................................................................................. 21
CROSS BEVELING ........................................................................................................................................... 22