Shopsmith Mark VII - Magna Molder; Saw Guards-Optional

Mark VII Restored Manual - V1.02 – Donated without cost to the world-wide Shopsmith Community - Everett L. Davis 2016 25
MAGNA MOLDER
The MAGNA Molder (Fig. 45) makes it possible to do edge
and surface molding operations on the table saw. It enables
even the beginner to increase the scope of his woodworking
projects and will add a professional touch to the simplest
construction. The MAGNA Molder mounts directly on the
SHOPSMITH spindle. Molding table insert must be used.
Here are some of the jobs you can do with the MAGNA
Molder: - mold decorative edges, form glue joints, tongue
and groove joints, make 1-3/8" sash, form countless
variations of moldings, cut rabbets and grooves (Fig. 46) and
many other operations which would be tedious or difficult
to do otherwise.
Always check tool clearance by rotating by hand before
making any cut with a molder.
SAW GUARDS-OPTIONAL
The SHOPSMITH lower sawdust collector/guard fits under
table and encloses the saw blade beneath the table,
providing also a sawdust chute for attaching the MARK VH
vacuum hose (Fig. 47) for virtually dust free operation.
(Item No. 505705)
The Upper Saw Guard mounts on the lower sawdust
collector/guard and provides a splitter to keep the kerf from
closing and binding the blade, anti-kickback fingers to
prevent blade from throwing the work back toward the
operator, and a self-adjusting blade guard above the table.
(Item No. 505627)